ADB over wireless
No root required
For wireless ADB without USB cable is possible but you need to use one time setup connection with PC using usb cable. make sure USB debugging mode should be on. Connect device on same wifi. then run
- adb tcpip 5555
- adb connect yourdeviceIP
To find current device IP and to setup adb wireless use app (without rooting device)
https://play.google.com/store/apps/details?id=com.freeappmakr.adb
Using this app you can setup your device with wireless adb.
If any error in setup use
adb kill-server
then try again
I ran into the same problem today and find that things are fine on my non-rooted 4.2 Galaxy Nexus device, but does not work on my older (again non-rooted) Samsung Galaxy Y (2.3) device.
I tried the steps given here but looks like one needs a rooted phone to work on some of the earlier models (and maybe other non-nexus devices too).
This is what I tried -
$ adb shell netstat | grep 5555
No socket was opened on this port.
Tried to manually set the steps that adb tcpip does -
$ adb shell setprop service.adb.tcp.port 5555
$ adb shell stop adbd
$ adb shell start adbd
$ adb shell getprop | grep adb
This does not show the property that was just set.
This is what it shows on my nexus device where it works without rooting -
$ adb shell getprop | grep adb
[service.adb.tcp.port]: [5555]
So depending on what phone/OS version u have, your mileage might vary.
:-)
Rooting is not required. With USB cable connected, port 5555 opened across all involved firewalls and debug mode enabled
adb tcpip 5555
then look into wireless properties of your device and the network you use, to see which IP address have been granted to device (or configure your DHCP always to use the same for the device mac address). Then
adb connect 192.168.1.133
(were 192.168.1.133 is a sample IP address).
This is all. You can now use adb shell or adb install or adb upload or the like with USB cable plugged out.
To switch back to USB mode,
adb usb
The device may also revert back to USB mode after reboot.
This mode is needed for development of applications that use attached USB devices directly (USB port is used by device so cannot be used by ADB). It is briefly covered in the USB debugging section of the Android website.
For wireless adb on my Nexus 4 @ Android 4.4.2 (Kitkat) I usually do:
- Turn on usb debug in 'Developer options'
- Connect via usb cable, accept an RSA key dialog
adb tcpip 5555adb connect 192.168.?.?(device IP on local wlan)Disconnect usb cable
Test if connection is still on:
adb devices- If ok you'll see:
List of devices attached192.168.?.?:5555 device - Else use Kumar's method:
https://stackoverflow.com/a/14855490/818634
- If ok you'll see: