Attribute Error: 'list' object has no attribute 'split'

I think you've actually got a wider confusion here.

The initial error is that you're trying to call split on the whole list of lines, and you can't split a list of strings, only a string. So, you need to split each line, not the whole thing.

And then you're doing for points in Type, and expecting each such points to give you a new x and y. But that isn't going to happen. Types is just two values, x and y, so first points will be x, and then points will be y, and then you'll be done. So, again, you need to loop over each line and get the x and y values from each line, not loop over a single Types from a single line.

So, everything has to go inside a loop over every line in the file, and do the split into x and y once for each line. Like this:

def getQuakeData():
    filename = input("Please enter the quake file: ")
    readfile = open(filename, "r")

    for line in readfile:
        Type = line.split(",")
        x = Type[1]
        y = Type[2]
        print(x,y)

getQuakeData()

As a side note, you really should close the file, ideally with a with statement, but I'll get to that at the end.

---

Interestingly, the problem here isn't that you're being too much of a newbie, but that you're trying to solve the problem in the same abstract way an expert would, and just don't know the details yet. This is completely doable; you just have to be explicit about mapping the functionality, rather than just doing it implicitly. Something like this:

def getQuakeData():
    filename = input("Please enter the quake file: ")
    readfile = open(filename, "r")
    readlines = readfile.readlines()
    Types = [line.split(",") for line in readlines]
    xs = [Type[1] for Type in Types]
    ys = [Type[2] for Type in Types]
    for x, y in zip(xs, ys):
        print(x,y)

getQuakeData()

Or, a better way to write that might be:

def getQuakeData():
    filename = input("Please enter the quake file: ")
    # Use with to make sure the file gets closed
    with open(filename, "r") as readfile:
        # no need for readlines; the file is already an iterable of lines
        # also, using generator expressions means no extra copies
        types = (line.split(",") for line in readfile)
        # iterate tuples, instead of two separate iterables, so no need for zip
        xys = ((type[1], type[2]) for type in types)
        for x, y in xys:
            print(x,y)

getQuakeData()

---

Finally, you may want to take a look at NumPy and Pandas, libraries which do give you a way to implicitly map functionality over a whole array or frame of data almost the same way you were trying to.

The problem is that readlines is a list of strings, each of which is a line of filename. Perhaps you meant:

for line in readlines:
    Type = line.split(",")
    x = Type[1]
    y = Type[2]
    print(x,y)