Convert linux software raid from raid5 to raid6

Solution 1:

The terminology you are looking for is a "RAID level migration".

According to this, it's possible. I haven't done it, but the procedure looks like you should add the new drive as a hotspare to the existing array, then use mdadm to update the raid level and the number of raid devices..

You'll need a recent mdadm to do this: mdadm-2.6.9 (eg, centos 5.x) doesn't seem to support it, but mdadm-3.1.4 (eg ubuntu 11.10) does:

   Grow   Grow (or shrink) an array, or otherwise reshape it in some way.  Currently supported growth options including changing the active size of component devices and
          changing the number of active devices in RAID levels 1/4/5/6, changing the RAID level between 1, 5, and 6, changing the chunk size and  layout  for  RAID5  and
          RAID5, as well as adding or removing a write-intent bitmap.

EG, add a new hotspare device, /dev/sdg, to the RAID5 array first:

$ sudo mdadm --manage /dev/md/md0 --add /dev/sdg

Then convert into a RAID6 array and make it rebuild to a clean state. The --raid-devices 4 tells you how many drives you have in total in the new array.

$ sudo mdadm --grow /dev/md/md0 --raid-devices 4 --level 6

I have no idea how quick this will be though. In my experience with doing raid level migrations on hardware RAID controllers, it's been quicker to create the new array from scratch and recover your backup to it.

Solution 2:

Obligatory warning: Plan for failure. Keep a backup ready and take possible downtime into account.

Also, test it in a VM or something similar before, this is from my notes and I haven't done this in a long time. This might be incomplete.

1. You will need to add the disks to the array:

   mdadm --manage /dev/md0 --add /dev/sdf  
   

   Do this for each of the three disks and replace the device names accordingly.

2. Grow the array:

   mdadm --grow /dev/md0 --level 6 --raid-devices 6 
   

---

Solution 3:

Make use of the --backup-file option, so in case of power loss you can continue to grow the device after a reboot and ensure no data loss.

mdadm --grow /dev/md0 --level=raid6 --raid-devices=6 --backup-file=/root/mdadm5-6_backup_md0

The backup-file should be saved on a filesystem not part of the array you are going to grow.

--backup-file= is needed when --grow is used to increase the number of raid-devices in a RAID5 or RAID6 if there are no spare devices available, or to shrink, change RAID level or layout. See the GROW MODE section below on RAID-DEVICES CHANGES. The file must be stored on a separate device, not on the RAID array being reshaped.

--continue is complementary to the --freeze-reshape option for assembly. It is needed when --grow operation is interrupted and it is not restarted automatically due to --freeze-reshape usage during array assembly. This option is used together with -G , ( --grow ) command and device for a pending reshape to be continued. All parameters required for reshape continuation will be read from array metadata. If initial --grow command had required --backup-file= option to be set, continuation option will require to have exactly the same backup file given as well.

Any other parameter passed together with --continue option will be ignored.