Gets the uncompressed size of this GZIPInputStream?

It is possible to determine the uncompressed size by reading the last four bytes of the gzipped file.

I found this solution here:

http://www.abeel.be/content/determine-uncompressed-size-gzip-file

Also from this link there is some example code (corrected to use long instead of int, to cope with sizes between 2GB and 4GB which would make an int wrap around):

RandomAccessFile raf = new RandomAccessFile(file, "r");
raf.seek(raf.length() - 4);
byte b4 = raf.read();
byte b3 = raf.read();
byte b2 = raf.read();
byte b1 = raf.read();
long val = ((long)b1 << 24) | ((long)b2 << 16) | ((long)b3 << 8) | (long)b4;
raf.close();

val is the length in bytes. Beware: you can not determine the correct uncompressed size, when the uncompressed file was greater than 4GB!

If you can guess at the compression ratio (a reasonable expectation if the data is similar to other data you've already processed), then you can work out the size of arbitrarily large files (with some error). Again, this assumes a file containing a single gzip stream. The following assumes the first size greater than 90% of the estimated size (based on estimated ratio) is the true size:

estCompRatio = 6.1;
RandomAccessFile raf = new RandomAccessFile(inputFilePath + ".gz", "r");
compLength = raf.length();
byte[] bytes = new byte[4];
raf.read(bytes);
uncLength = ByteBuffer.wrap(bytes).order(ByteOrder.LITTLE_ENDIAN).getInt();
raf.seek(compLength - 4);
uncLength = raf.readInt();
while(uncLength < (compLength * estCompRatio * 0.9)){
  uncLength += (1L << 32);
}

[setting estCompRatio to 0 is equivalent to @Alexander's answer]

Based on @Alexander's answer:

RandomAccessFile raf = new RandomAccessFile(inputFilePath + ".gz", "r");
raf.seek(raf.length() - 4);
byte[] bytes = new byte[4];
raf.read(bytes);
fileSize = ByteBuffer.wrap(bytes).order(ByteOrder.LITTLE_ENDIAN).getInt();
if (fileSize < 0)
  fileSize += (1L << 32);
raf.close();

Is there a similiar method like ZipEntry.getSize() for GZIPInputStream

No. It's not in the Javadoc => it doesn't exist.

What do you need the length for?