How to convert between bytes and strings in Python 3?

The 'mangler' in the above code sample was doing the equivalent of this:

bytesThing = stringThing.encode(encoding='UTF-8')

There are other ways to write this (notably using bytes(stringThing, encoding='UTF-8'), but the above syntax makes it obvious what is going on, and also what to do to recover the string:

newStringThing = bytesThing.decode(encoding='UTF-8')

When we do this, the original string is recovered.

Note, using str(bytesThing) just transcribes all the gobbledegook without converting it back into Unicode, unless you specifically request UTF-8, viz., str(bytesThing, encoding='UTF-8'). No error is reported if the encoding is not specified.

In python3, there is a bytes() method that is in the same format as encode().

str1 = b'hello world'
str2 = bytes("hello world", encoding="UTF-8")
print(str1 == str2) # Returns True

I didn't read anything about this in the docs, but perhaps I wasn't looking in the right place. This way you can explicitly turn strings into byte streams and have it more readable than using encode and decode, and without having to prefex b in front of quotes.

TRY THIS:

StringVariable=ByteVariable.decode('UTF-8','ignore')

TO TEST TYPE:

print(type(StringVariable))

Here 'StringVariable' represented as a string. 'ByteVariable' represent as Byte. Its not relevent to question Variables..

This is a Python 101 type question,

It's a simple question but one where the answer is not so simple.

---

In python3, a "bytes" object represents a sequence of bytes, a "string" object represents a sequence of unicode code points.

To convert between from "bytes" to "string" and from "string" back to "bytes" you use the bytes.decode and string.encode functions. These functions take two parameters, an encoding and an error handling policy.

Sadly there are an awful lot of cases where sequences of bytes are used to represent text, but it is not necessarily well-defined what encoding is being used. Take for example filenames on unix-like systems, as far as the kernel is concerned they are a sequence of bytes with a handful of special values, on most modern distros most filenames will be UTF-8 but there is no gaurantee that all filenames will be.

If you want to write robust software then you need to think carefully about those parameters. You need to think carefully about what encoding the bytes are supposed to be in and how you will handle the case where they turn out not to be a valid sequence of bytes for the encoding you thought they should be in. Python defaults to UTF-8 and erroring out on any byte sequence that is not valid UTF-8.

print(bytesThing)

Python uses "repr" as a fallback conversion to string. repr attempts to produce python code that will recreate the object. In the case of a bytes object this means among other things escaping bytes outside the printable ascii range.