Apple - iMac 27" late 2012 SSD upgrade
I have an iMac 27 Late 2012 and I upgraded my SSD.
The fusion drive is a misnomer - it's actually two drives. There is an PCIe SSD, probably about 128GB that attached to the logic board, then there's a 3.5" 1TB HDD. Technically, you could upgrade the PCIe blade SSD drive, but after some research, I found it wasn't really economical.
All you need is a standard SSD to replace that HDD. You then create a fusion drive using CoreStorage and you will end up with an SSD with 1.13 TB of total storage.
As per Everymac.com....
The basic steps for this upgrade are:
- Back up data
- Remove the screen
- Replace the SSD (you will need a 3.5" to 2.5" HDD adapter
- Replace the screen
- Reinstall / Restore from Backup.
I've actually answered this question on another thread: 27 imac Late 2012 HDD Failure
While you are doing all these upgrades, I would upgrade the memory as well. I used Crucial Memory and your iMac can get up to 32GB of RAM
The slot is proprietary, and it is not an M.2 or mSATA slot.
I have seen no adapters on the market that will allow you to connect an ordinary SATA drive to the proprietary connector. Such an adapter would need to include an amount of electronics, as it is a completely different interface - i.e. it is not just a passive adapter.
The only other supplier of compatible SSDs than Apple that I know of is OWC (Macsales). They have a series of SSDs (Aura 6G) compatible with the late 2012 model of the 27" iMac:
https://eshop.macsales.com/shop/ssd/owc/imac-27-inch/2012
I can confirm that swapping the apple SSD for some other SSD is possible in the late 2012 iMac. But I can also confirm that the connector used by the Apple SSD is not mSATA: Although it has the same pin layout, the pins are smaller and don't fit the connector of an mSATA SSD.
Fortunately, I can confirm a third thing: There are adaptors available to convert this proprietary apple connector to a standard mSATA connector. Those are easily found on the Internet on various online shops, and usually called "iMac 2012 mSATA adaptor" or anything similar. I only found one called "MacBook Pro 2012 mSATA adaptor", but that one worked as well, so the connector in 2012 MacBook Pro seems to be the same as the one in my iMac.
Still, use such adaptors with caution! Even if it's really low-tech (narrowing the pin layout a bit, no electronics needed), they may be faulty and might damage to your hardware.
Furthermore, don't forget about the fan issue when swapping the HDD as well: The iMac's internal fan controller won't recognize the HDD temperature of a non-pre installed HDD, even if it's the same brand and model: Apple has built proprietary firmware for the drives shipped with Macs, probably to prevent users from swapping them. I can confirm that this issue applies for the late 2012 iMac as well.
See my photos for pin differences of the original Apple SSD and the mSATA SSD, as well as the installed adaptor.
