What is the relationship of DMA ring buffer and TX/RX ring for a network card?
Short Answer: These are the same.
More details: First, see this post which is very related to your question.
In this article it says:
A variant of the asynchronous approach is often seen with network cards. These cards often expect to see a circular buffer (often called a DMA ring buffer) established in memory shared with the processor; each incoming packet is placed in the next available buffer in the ring, and an interrupt is signaled. The driver then passes the network packets to the rest of the kernel, and places a new DMA buffer in the ring.
The DMA ring allows the NIC to directly access the memory used by the software. The software (NIC's driver in the kernel case) is allocating memory for the rings and then mapping it as DMA memory, so the NIC would know it may access it. TX packets will be created in this memory by the software and will be read and transmitted by the NIC (usually after the software signals the NIC it should start transmitting). RX packets will be written to this memory by the NIC and will be read and processed by the software (usually after an interrupt is issued to signal there's work).
Hope this helps.
Ring Buffer Contains Start and End Address of Buffer in RAM. TX Ring will contain addresses of Buffer in RAM that contains data to be transmitted. RX Ring will contains address of Buffer in RAM where NIC will place data.
These rings are present in RAM.
TX buffer and RX buffer are are in RAM pointed by TX/RX rings.
Now Network Card Register has Location of Rings Buffer in RAM .
Now 1 and 2 can be DMA able buffer , they are called DMA TX/RX ring and DMA TX/RX buffer. Now since RX/TX ring must remain throughout they are made as consistent/coherent DMA type of meory. While Buffers are made streaming/Single DMA type of memory
