Packet capture in RDMA?

Chelsio's T4 device supports a packet trace feature allowing it to replicate ingress/egress offload packets to one of the device's NIC queues. Then you can use tcpdump or whatever on that ethX interface to see the RDMA or TOE packets.

Old thread, but still:

As Roland pointed out, sniffing RDMA traffic is tricky, because once the endpoints did the initial handshake, traffic goes through network card (HCA) directly to the memory. The only way to sniff this traffic w/o putting a dedicated HW sniffer on the wire is to have vendor-specific hooks in the network card, and a SW tool that uses these hooks.

If you have Mellanox HCAs, you can use the "ibdump" tool. This tool is also a part of Mellanox OFED package.

If you have other vendor's HW, you need to check with that vendor - you won't find any open-source packet sniffer for all RDMA-capable devices, sorry.

In general, no. One of the main characteristics of RDMA is that all the network processing is done on the adapter, without involving the CPU at all. Typically work requests are queued up directly from userspace to the adapter, without any system call. So there's nowhere for a sniffer to hook in to get traffic.

With that said, for Ethernet protocols, iWARP or IBoE (aka RoCE), you can hook up a system in the middle of a connection and set it up to do forwarding in software (eg the Linux bridge module) and then run tcpdump or wireshark to capture the RDMA traffic that passes through this system. Wireshark even has dissectors for iWARP and IBoE.

For native InfiniBand it is theoretically possible to build something similar (set up an adapter to capture and forward traffic) but as far as I know, no one has done even the needed firmware or driver work to do basic packet sniffing.