Keynote won't update

Here are the steps you need to add a new custom resolution and apply it. Following steps are for adding a 1920x1080 resolution, but you can use it for any other resolution you want. But make sure your monitor and onboard graphics support that resolution.

# First we need to get the modeline string for xrandr
# Luckily, the tool "gtf" will help you calculate it.
# All you have to do is to pass the resolution & the-
# refresh-rate as the command parameters:
gtf 1920 1080 60

# In this case, the horizontal resolution is 1920px the
# vertical resolution is 1080px & refresh-rate is 60Hz.
# IMPORTANT: BE SURE THE MONITOR SUPPORTS THE RESOLUTION

# Typically, it outputs a line starting with "Modeline"
# e.g. "1920x1080_60.00"  172.80  1920 2040 2248 2576  1080 1081 1084 1118  -HSync +Vsync
# Copy this entire string (except for the starting "Modeline")

# Now, use "xrandr" to make the system recognize a new
# display mode. Pass the copied string as the parameter
# to the --newmode option:
xrandr --newmode "1920x1080_60.00"  172.80  1920 2040 2248 2576  1080 1081 1084 1118  -HSync +Vsync

# Well, the string within the quotes is the nick/alias
# of the display mode - you can as well pass something
# as "MyAwesomeHDResolution". But, careful! :-|

# Then all you have to do is to add the new mode to the
# display you want to apply, like this:
xrandr --addmode VGA1 "1920x1080_60.00"

# VGA1 is the display name, it might differ for you.
# Run "xrandr" without any parameters to be sure.
# The last parameter is the mode-alias/name which
# you've set in the previous command (--newmode)

# It should add the new mode to the display & apply it.
# Usually unlikely, but if it doesn't apply automatically
# then force it with this command:
xrandr --output VGA1 --mode "1920x1080_60.00"

Original source: https://gist.github.com/debloper/2793261

I also wrote a script that does all these steps automatically. You can try it out if the above steps seem too complicated for you: https://gist.github.com/chirag64/7853413

The option --size/-s can be used:

xrandr -s 1440x900

Should work with RandR version 1.1 or newer.

You have not given the compiler anything to publish. Just put Hi right before the \end to verify this. And you need to move some content around and add a command for the titlepage as follows

\documentclass{article}
\title{Identification of potential therapeutic targets in human breast cancer}
\author{myName}
\date{August 2015}
\begin{document}
\maketitle
hi

\end{document}