What would be the disadvantages of using a 4 stranded ethernet cable?

Standard 100 base ethernet only uses two pairs so this works... what is a little worrisome is it appears someone did it on the cheap and saved a couple of cents by omitting the other pairs. That said, 1000 base ethernet may use all four pairs and this cable can't handle that.

I ended up doing some tests myself, and the results were... frankly appalling.

TLDR: Throw out the cable.

Now on to some science.

To address some concerns that were stated in the comments - the initial testing was done on a undamaged cable - I only cut it open after the speed tests. I've repeated the tests with an identical cable from the same kit, and have found the same results. I've also repeated the tests with the 'proper' cat 5 cables with 4 other cables.

I tested this by connecting two systems to the same switch, and swapping out the cable on one of them. I also used the free version of LAN Speed Test to do some 'quick' performance testing. I'm running the test from my laptop to a share on a 3tb 7200 rpm drive on my desktop. I'm testing the cables at this point, not overall bandwidth, under conditions reasonably similar to real-world situations for me.

I was thinking of doing a direct system to system speed test as well, without the bridge, but looking at my results, that would be a clear waste of time.

Let's start off with the most obvious things.

The 4 stranded cable isn't capable of gigabit ethernet (no surprise there). In fact, it can't even do fast ethernet.

The speed test took a while to complete... in fact, I had dinner in the time it was running and the total time was about 2 hours to write and about as long to read.

It's pretty close to plain vanilla 10baseTX speeds by the looks of things.

Less obviously? No IPV6. I have no idea what's with that. I've had enough oddness with legacy gear that I'm not even going to touch on this.

I actually tested 2 random 'to spec' cat5 cables from my spares bin. Both have UL marks, and had similar enough performance that I'm only going to post one set of results. These detect as 'proper' gig-e cables. Both were freebies from routers, so it's not like I'm comparing apples and oranges.

Gigabit Ethernet Sweetness!

And have performance that's pretty reasonable - taking into account various overheads like the test writing to a file share.

Yes, that's about 200 seconds total vs about 4 hours. And Ipv6 works perfectly.

Even with the devices it came with - which could easily reach up to 80-100Mbps, the cable might have fallen short. It's clearly not cat 5 e as labelled, and in my specific use, it's clearly unacceptably slow. If I wasn't planning on documenting this, I'd probably have stopped the test for the other cable sooner.

Most of the time, these cables still include the other 2 pairs in the cable itself, but they don't crimp them. So you can make them real Ethernet cables with the proper tools.

I assume they do this so they can sell "Gigabit" Ethernet cables at a higher price.